[lwlan-devel] Intermittent errors on boot

[Jim Ham]

Hello again,

I found a image for the Arcom Viper that uses a newer kernel - 2.6.21.7. 
I've installed this and remade wlan-ng for the new kernel. BIG 
difference. I'm not getting the error about missing the interrupt. There 
are still a couple of error messages on boot, and ifup doesn't run 
automatically. Hotplug doesn't restart the radio either, but this is a 
minor issue. I can do it by hand and it works

I still had to remove the extra condition for find in /etc/wlan/shared. 
Busybox find doesn't know about '-a'.

Other than that all runs right out of the box.

I've attached a boot log. Note that when /etc/init.d/wlan runs you get 
errors about missing modules. I do have the alias in modules.conf. 
Despite this message the radio is set up correctly, although for some 
reason ifup doesn't run.

With this newer setup things are looking much brighter. I think I can 
actually use this hardware.

Regards,

Jim Ham



-------------- next part --------------
An embedded and charset-unspecified text was scrubbed...
Name: bootlog21
Url: http://lists.linux-wlan.com/pipermail/linux-wlan-devel/attachments/20080623/2b440cf7/attachment.pl